Adjustable Headrest Tablet Mount with Rotating Ball Joint and Extending Arm

Keep Kids Entertained On Long Drives With This Headrest Tablet Mount

You're stuck in traffic and the kids start whining from the backseat again. You've run out of games to play, and everyone's getting restless as the drive drags on. This mount lets you clip a tablet between the front seats so kids can watch movies during road trips, doctor visits, or daily commutes.

This holder clamps onto your headrest bars using a screw hook that tightens into place. The extending arm pulls out from 2.36 to 10.63 inches and swings left or right between both rear passengers. A rotating ball joint at the base turns a full circle so you can tilt the screen up, down, or sideways until it sits at the right viewing angle.

The extending arm adjusts to different lengths so smaller kids can reach the screen up close. It holds devices from 4.7 to 12.9 inches wide, fitting most tablets without removing their cases. The holder works with headrest bars spaced between 0.39 and 6.3 inches apart, covering most sedans, trucks, and larger vehicles.

The clamp hooks onto metal headrest bars and stays put during turns and sudden stops. Rubber pads line the inside edges to grip your device without scratching the screen or back panel. The folded unit measures 10.83 by 4.96 by 2.17 inches and weighs 11.6 ounces, storing flat when not in use.

• EXTENDS UP TO 10.63 INCHES: Pull the arm out to bring the screen closer to smaller passengers or push it back for older kids sitting farther away.
  
  
• FITS 4.7 TO 12.9 INCH DEVICES: Holds most tablets securely in place without forcing you to remove protective cases or covers during installation.
  
  
• SWINGS BETWEEN BOTH SEATS: Move the tablet left or right so either rear passenger can watch shows without leaning over or straining their neck.
  
  
• FULL CIRCLE ROTATION: Twist the ball joint to position the screen horizontally for movies or vertically for reading apps and games.
  
  
• RUBBER GRIP PADS: Soft padding holds your device steady without leaving marks on the glass or scratching the metal edges during bumpy rides.
  
  
• WORKS WITH WIDER HEADRESTS: Clamps onto bars spaced up to 6.3 inches apart, fitting trucks, vans, and larger vehicles with thicker seat designs.
  
  
• INSTALLS WITHOUT TOOLS: Tighten the screw hook by hand to lock the mount onto your headrest bars in under a minute.
  
  
• FOLDS DOWN FLAT: Collapse the arm and store the mount under your seat or in the trunk when you're not using it.

HEADREST TABLET MOUNT SPECS

• Material: ABS, Aluminum Alloy, Silicone
  
  
• Folded Size: 10.83 x 4.96 x 2.17 Inches
  
  
• Extension Length: 2.36 to 10.63 Inches
  
  
• Device Compatibility: 4.7 to 12.9 Inches
  
  
• Headrest Bar Spacing: 0.39 to 6.3 Inches
  
  
• Weight: 11.6 Ounces

PACKAGE INCLUDES:

• 1 x Headrest Tablet Mount