Two-Part Metal Epoxy Adhesive with 95 MPa Bond Strength and Machinable Surface

Fix Cracked Metal Parts Fast With This Repair Glue

You spot a crack spreading across your toolbox and know it'll snap completely soon. Hauling everything to a repair shop costs time and money you don't have. This glue bonds broken metal pieces back together in your garage, letting you fix split brackets, cracked engine parts, or broken handles yourself.

Squeeze equal amounts from both tubes and stir them until the mixture looks smooth. Spread the blend over the damaged area and press it into cracks or gaps. The bond firms up in 60 minutes and reaches full hardness after 24 hours.

The cured bond holds between 82 and 95 megapascals of force and survives temperatures from negative 40 to 392 degrees. You can drill holes through it, cut threads into it, sand the surface flat, or paint over it once it sets. It bonds to steel, aluminum, and cast iron surfaces.

The hardened surface blocks water, oil, mildew, and rust from getting through. It stays locked in place on fuel tanks, pump housings, appliance frames, and motor mounts. You skip torches, welding rigs, and electrical equipment entirely.

• 95 MEGAPASCAL BOND STRENGTH: Creates repairs stronger than most original metal parts, holding tight under heavy loads and constant stress.
  
  
• NEGATIVE 40 TO 392 DEGREE RANGE: Maintains full bonding power through freezing winters and scorching engine bay heat without cracking or loosening up.
  
  
• FULLY MACHINABLE SURFACE: Drill through it, tap threads, sand smooth, or paint directly over the cured repair like working with solid metal.
  
  
• EQUAL PARTS MIXING: Squeeze matching amounts from each tube and blend together with no measuring cups, scales, or complicated ratios needed.
  
  
• BONDS ALL COMMON METALS: Sticks permanently to steel, aluminum, and cast iron parts without primers, special surface prep, or extra adhesion steps.
  
  
• COMPLETE SEAL PROTECTION: Blocks water, oil, mildew, and corrosion from penetrating repaired areas while resisting impacts and vibration after curing fully.
  
  
• 60 MINUTE INITIAL SET: Firms up enough to handle within one hour, then reaches maximum bonding strength after 24 hours of curing time.
  
  
• NO HEAT OR SPARKS: Works without welding torches, electrical equipment, or open flames, letting you make solid repairs safely in any workspace.

METAL REPAIR GLUE SPECS

• Initial Set Time: 60 Minutes
  
  
• Full Cure Time: 24 Hours
  
  
• Compressive Strength: 82 to 95 MPa
  
  
• Density: 99.8 to 115.4 lb/ft3
  
  
• Temperature Range: Negative 40°F to 392°F
  
  
• Mixing Ratio: 1:1
  
  
• Compatible Metals: Steel, Aluminum, Cast Iron
  
  
• Resistance: Water, Oil, Mildew, Corrosion
  
  
• Post Cure Work: Drilling, Tapping, Sanding, Painting

PACKAGE INCLUDES:

• 1 x Metal Repair Glue